Architectural Information:
Fan forced electric air heaters shall be ETL listed, factory dual field rated 208V/240V. The painted wall mounting can for this heater is made from 20-gauge sheet steel with six electrical knockouts and 34 cubic inches for a wiring compartment. Each complete heater shall be of unitized construction and attach to the wall can with a single screw and shall be self-contained and completely separate from the wall mounting can. Element construction is a coiled nichrome heating wire sealed in a steel sheath with steel fins brazed to the sheath. Heating unit shall include a 16-amp rating at 240V, high temperature manual reset limit switch. A two stage centrifugal blower shall be driven by an impedance protected motor. The motor shall be totally isolated from the heating chamber. Metal grills shall be of one piece, constructed of 22-gauge steel and finished with a powder coat paint system.

Technical Information:
The wall can and the Com-Pak Max heater assembly may be installed vertically or horizontally. The Com-Pak Plus grill may be installed vertically or horizontally. The Com-Pak Max register style grill may only be installed horizontally. The (vertical installation) Com-Pak Max may be ordered with or without a built-in thermostat. For optimal comfort use a Cadet electronic thermostat. Fan heaters and thermostats work best when installed on an inside wall. UL requires heater to be placed a minimum distance of 6” from adjacent surfaces and 4.5” from the floor. Manufacturer recommends installation 12” from all surfaces. A 3’ minimum clearance is recommended for furniture or other objects placed directly in front of heater. Not approved for ceiling mount.

NOTE: Manufacturer recommends installing heater assembly after walls are finished. Heater must be cleaned every six months minimum. All CM models are ETL approved to UL and CSA standards.

Ordering Information:
The heater assembly, Com-Pak Plus grill and Com-Pak Max register style grill are all separate components and shall be ordered separately. Suffix “T” in model number denotes built-in single pole thermostat. Model numbers without a “T” require a thermostat. Recommended for elevations under 10,000 feet. Available in white or almond.


Rough In Dimensions: Horizontal Mount - 10.25"W x 8"H x 4"D

Wall Can Dimensions: Horizontal Mount - 11.5"W x 7.875"H x 4"D

Grill Dimensions: Horizontal grill – 12"W x 9"H